- #Wansview app windows 720p#
- #Wansview app windows install#
- #Wansview app windows manual#
- #Wansview app windows software#
- #Wansview app windows password#
When the trialĮnds, you will need to order a subscription to continue using the service.Īssuming you already have a CameraFTP Account, then you need to enter the following info: If Wi-Fi is configured successfully, you can unplug your network cable later.Ĭlick Advanced à FTP, you can see the screen as shown above.
The wireless password, after done, click Save. In the Wi-Fi setup screen, click Search to find a list of Wi-Fi networks and select one to connect. Otherwise, click the Network tab, then click Wi-Fi. If you had already connected the camera with your wireless router, then skip this step. These steps in the Camera Configuration screen to make sure everything is configured correctly). With CameraFTP's service, most regular setup steps are not required. Click Advanced and then click the FTP, you can enter the FTP information as shown in the screenshot below.
#Wansview app windows install#
(It is recommendedĪfter you log on to the camera, please install the Plug-in:Ĭlick Setup, you will see the Setup Main screen.
#Wansview app windows password#
The default username is admin, and password is 123456. So please download Firefox web browser if you don't have it already. Most IP cameras don't support Chrome, incl. Step 2: Configure the Camera Using the Web-based In the screenshot below, you need to check "Set IP automatically" In this case, you must use the manufacturer's IP search tool to find the camera and then change it to use dynamic IP address (DHCP). if the default camera IP address is 192.168.0.168, and the PC's IP address is 192.168.1.101), then VSS cannot find the camera. If the default static IP address is not in the same subnet as the PC (e.g. NCM620W) use a static IP address as the default IP address. You can use VSS as a cloud-enabled NVR, which requires a PC. Note: This camera is compatible with VSS-based Cloud Recording. ( After you find the camera's IP address, you can stop / uninstall VSS.
#Wansview app windows software#
If your computerĭoes not have a DVD/CD drive, then you can download CameraFTP VSS software to find the camera's IP address. Usually you will run the included IP Camera Search Tool to find the camera.
#Wansview app windows manual#
Please refer to the manufacturer’s manual for more detailed information. In about 1 minute, you will see the status light changes, indicating it is connected Seconds the WPS button will usually start flashing. For Wi-Fi only cameras, you must use manufacturer's mobile app to connect it to the network.Īccess point/router supports WPS, then it is very easy to connect your deviceĬamera and press the WPS button on your Wi-Fi access point (router) for 3 Router does not support WPS, then you can connect the camera with the Please read the product manual for detailed instructions. Otherwise, there are several ways to connect the IPĬamera to your Wi-Fi network. If you want to use wired connection, you just need to connect the Ethernet cable.
To the network and find IP address 1.1 Connect camera to the network If you have finished these basic steps before, Manufacturer for all camera-related issues and contact us only forĬameraFTP-related (cloud service / FTP) issues. It may not be accurate or completely up-to-date. The information provided isīased on our knowledge of the models Wansview NCM621W (Outdoor) and NCM620W (indoor PTZ) cameras. Replace the product manual from the manufacturer. Image recording at 1 image/5s or lower frequency Supported for video recording when the motion sensitivity is set to 100. Supported for both image and video clip based recording Up to 75 feet (outdoor), 24 feet (indoor PTZ)